Liczymy pasujące modele…
This fastener is sized for a 6mm hole, with a 14.1mm head diameter. It can be scaled as needed. The model is based on the dimensions of Honda part no. 90683-GR1-003. I used it to attach body panels on a Honda CBR929RR. Compared to other…
Three of these cleats are on the Hobie 16 mast: the jib and main halyard are riveted; the downhaul is attached to the luff groove with special square nuts. Parts required to install as a halyard cleat: - 2x 3/16x5/8" 6-10 stainless steel…
These parts are used in the lower rudder castings on the Hobie 16 to adjust rudder tension. They are designed to replace the original acetal screws and plungers. The factory adjustment screws require an unusually wide flathead…
I settled on this foregrip design after extensive ergonomic testing. It provides excellent control in C-clamp and vertical grip styles. Reversible according to your preference. Features: - 75mm grip height - 13° sweep angle -…
The top rack adjuster assembly (part WPW10546503 ) on several models of KitchenAid, Whirlpool, and Kenmore dishwashers is highly loaded and very underbuilt. I designed these snap-fit adjusters to replace the factory parts. They are…
A follower for a KWA-style P226/M226 magazine. I used PLA, but PETG would be a better choice. Recommended Print Settings Material Nozzle Layer Height Strength Supports PETG 0.4mm 0.1mm 100% infill Yes
These nuts were used in Hobie 16s and 14s until the mid-1980s. They were replaced by stainless steel nylocks (part #8050310), but still work pretty well. This design uses ANSI #5/16-18 threads. After printing, I ran the nut up and down a…
These parts are used along with a nut, a bolt, and a spring to connect a Hobie 16 rudder tiller to the crossbar. Each tiller connector requires 1 large washer and 2 domes. The washers are concave on one face to improve fit-- it doesn't…
To wszystkie aktualnie dostępne wyniki.
