Liczymy pasujące modele…
These covers make removing the tape used to hold a sensor on easy to remove if needed without tearing the sensor off. There is a template so you can make your own adhesive patches. This is used with the larger cover. The smaller cover…
There are lots of these on here already. This one was designed for the F8X14X4mm thrust bearings I had left over from another project. This was printed in ASA, PETG probably would be good enough. I did have to run a 5mm drill bit through…
This is used with Stepperonline 42x48 stepper motor model 17HE19-2004S. Used with Uxcell 9x20x7 Thrust Bearings purchased from Amazon. Tried another brand from Aliexpress and they were the same dimensions. This was printed in ASA, Part…
Device to hold the edge of the bowl down when making girdles. PLA is fine to use to make it. Found a new bowl online and picked it up for quite a bit less than they are selling for now. I want to keep it in good shape so decided to make…
This a a mount and case for the Fly RRF-36 can-fd toolboard for Duet or other RRF based boards. I printed it in ABS and will solvent weld the mount to the band. And weld the two washers on the rear of the mount to give it enough depth for…
Save your grinding disk and possibly valuable material.. This is for large stones that would take a long time to shape .Works with a 6 inch saw blade or smaller if you are using a 6 inch faceting machine. Thin blades will possibly warp if…
used to hold a DS18B20 temperature sensor into a 1 1/4 pool hose. We have an Intex above ground pool. I designed a pool pump timer for it that includes control of a solar heater. Used 1 ID o-rings on it. The fitting was very tight. I…
This is a replacement for the tool supplied by Leak Stoppers ( https://leak-stopper.com/ ). Mine was missing thanks to the package coming open. But from what I see all it was is a wood dowel with a stepped hole drilled in it. I created…
If you use a lap that has a smooth bottom when it is not spinning you need to turn the water off. If you do not water can run under the lap and get into the space between the platen and the base and possibly damage the bearings. I made…
A replacement cover for the lap screw. Mine became gummy so I made a replacement cover for it. Printed in TPU. Cut the old one off and push this one on. If needed it can be warmed a bit with a hair dryer but should go on with a little…
Small case for index gears.
To wszystkie aktualnie dostępne wyniki.
