Liczymy pasujące modele…
The idea behind these feet was to find the best possible equation among 4 variables: they should be solid enough to firmly hold the heavy printer in place (should be reasonably massive ); they should be wide enough to mitigate as much…
Cheap (the AlEx kind) 100mm length by 38mm inner diameter sticky lint cleaner rolls are a tad wider than the IKEA BASTIS ones. Thus the IKEA roller doesn't perform too good with them. Here's a simple print-in-place roller for those. No…
Building an Enderwire, I have found out that the screen cover wasn't quite suitable for the MKS mini12864 v3 I own. It has different PCB dimensions, a beeper on the back and slightly different components layout versus the BTT (?)…
When I Klipperized my e3v3se, I didn't want the pi to hang on the outside, so I bought the external antenna (OPiZ3 uses IPEX-4 connector) and modeled this simple bracket to mount both the OPiZ3 and the LM2596S buck converter inside of the…
I am building an Enderwire and I have an OrangePI Zero3 on hand. Couldn't find a mount for it and had to design one myself. Inspired by the original project and built from scratch.
A friend of mine had both lower rubber pads on his Xiaomi tripod selfie stick fall out and one of them completely missing. So he asked me if I could remodel the remaining one and print them. Printed them in ABS on my Qidi Q2 with 0.4…
I'm currently building an Encore with the parts I have lying around. My idea is to klipperize it from the get-go. So I needed an MCU bracket for the BTT E3v3 + OPiZ3 + LM2596S. In case anyone has the same parts set - there you have it.
While building my direct drive klipperized Encore I decided to give it the AC bed heater. So here's my personal version of making it all tidy and safe. It requires an additional 2 M4 stopnuts and 2 M4x(10-12) screws. Also you will need to…
Here is my remix of the Encore's original toolhead parts to fit Dmitry Sorkin's direct drive Minifeeder on it. I've opted to not use any adapters, because I wanted to save the Encore's original looks, which I like a lot. So I had to remix…
To wszystkie aktualnie dostępne wyniki.
