Liczymy pasujące modele…
My ThermoSpa's(Manhattan II) filter doesn't have documented dimensions(that I can find). Buying the filters direct from ThermoSpa is an option, but it's roughly 2x the cost of other filters on Amazon. I made this adapter to allow me to…
This adapter attaches to the Hisense AC unit. The dimensions of the connection on the back of the unit are roughly 162mm x 125mm. This adapts to a 6 inch diameter hose. The exhaust gets hot! I tried to print this in PLA(I knew it was a…
Print Settings Choose a filament that meets the temperature and strength needs of the adapter. I chose ASA GF . Infill: 40% Adaptive Cubic. This is not critical and is somewhat dependent on the application. It is recommended to use 100%…
Converts a 1" wide ruler to a basic caliper which is able to measure both inside and outside diameters. I used this model, specifically, with a 16" Pittsburgh ruler from Harbor Freight. It was printed in PLA with an infill of 30%, though…
This tool has a 1/4" shank and is inserted into the chuck of the router. The shank will likely need to be sanded to ensure a straight fit in the chuck. I have used this tool to tram my LowRider 3. After tramming with this tool, I was able…
Layer Height: 0.2mm Filament: PLA Infill: 35%-45% Supports: Yes
Our church is a pop-up church that meets in a local school. In order to have a place to put bulletins, notes, pens, etc.. I designed this simple card holder. I've mass produced over 300 of these and they work great! This design is printed…
I designed this probe to help me determine the z variance of my spoil board but it could also be used to help build a mesh for uneven stock. The probe is designed to press-fit over the endmill. It is possible to modify the probe to…
Status: April 3. 2026 - The printer has been working well on the base. I'm working on pictures of the wiring. Note: This project is very much a work in progress. Models will change but I'm looking for feedback on the model, consideration…
I needed an easy way to direct the 1/4" air line from my air assist to my LASER TREE 4W Laser Engraver Module. I designed this model to do just that. Laser: https://link.amazon/B0c9JEz2f Air Assist: https://link.amazon/B0cVDrWfG As an…
Our chihuahua, Ollie, likes to pop through the slats in the wooden fence and get in to trouble. That is why I made this model. Four slots split the ring into flexible segments so it opens up to go on, and you can dial the overall firmness…
GT2 9 mm Zip Tie Belt Tensioner — 23.5 mm Conduit Clips onto a 23.5 mm conduit rail. The belt end drops into a retention slot at the end of the tensioner, and a zip tie through the body pulls it tight. No screws or other hardware…
This support helps guide and hold the toolhead umbilical in a controlled overhead loop, keeping cables, bowden tube, etc... clear of the build area as the toolhead moves. It’s shown installed on my large-format 600 × 600 mm CoreXY…
To wszystkie aktualnie dostępne wyniki.
