Liczymy pasujące modele…
Connector housing for DC-5521 / DC5521 low voltage connectors. I did not like that there is no strain relief when attaching cables to the typical DC-5521 connectors you get on eBay or Amazon, so I designed these housings. I left the area…
Adapter um Proxxon Micromot Geräte mit 20mm Aufnahme in eine Bohrmaschinen Tischklemme einzuspannen. Eine Version für meine alte Tischklemme mit dem ungewöhnlichen Durchmesser 37mm, die Zweite für den normalen 43mm Euro Spannhals…
Lots of nice bookends available, so what makes this one special? Freely configurable, OpenSCAD Sourcecode included. Simply change values according your needs. Depending the outer dimensions patterns are automatically generated and…
Adapter zur Aufnahme von Proxxon Micromot Geräten mit 20mm Spannhals in einem Schraubstock. Eine Version für Maschinen Schraubstöcke, die zweite Version mit Anschlag um es in einen regulären Schraubstock zu spannen. Es werden 2 Schrauben,…
Socks frame for electronic embroidery machines, fits into 10 x 10cm frames. OpenSCAD Source Code included How-To-Use is shown in the pictures. Clamp in self adhesive embroidery stabilizer into your machine frame and attach socks frame on…
Gürtel Köcher Scheibenreinigung, für Abzieher und Einwascher 35cm. Erstellt mit OpenSCAD. Das Modell ist in den Abmessungen frei konfigurierbar. Die einzelnen Elemente des Köcher sind als Module kreiert, diese können dann final am Ende…
Prusa MK2 and MK2.5 clip for display flatcable, replacement for broken ones. Printed on my MK3s with PLA+ and PETG, 100% Infill. Both materials seem to work fine, possible better to use PETG in warm environments to last longer
The thumbstick rubber caps from my Sony Playstation (c) controllers for the PS2 and PS4 became greasy and sticky. So I designed these caps with different symbols. Printed on my Prusa MK3 and Textur printsheet, with filament Overture TPU…
I replaced the old clutch Motor from my Adler 167-73 compound feed sewing machine by a modern Servo Motor. The Servo motor included a needle positioning sensor with inside diameter 22mm, so I needed an adapter to attach it. Printed with…
Replacement bobbin for my Adler 87 Sewing machine, dimension 24 x 8.5mm and 6mm hole Such a bobbin is hard to print in one piece, possible with a Resin-Printer. The main focus for this model was to get it as accurate as possible, and easy…
Adapter um Reibung oder Beschädigung von Filament Spulen aus Pappe zu verhindern. Der Kern des Modell hat die Größe 100mm, im Slicer kann somit einfach ohne Umrechnen auf den gemessenen Durchmesser der Pappspule reduziert werden. Nur X…
I purchased an older Prusa i3 MK2.5 and wanted to operate it on my network. An old Raspberry Pi 1b and Wifi USB-dongle was lying around, so I gave it a try and tested to install Prusa Link on it, runs perfect.…
Just another square to manually adjust the Z-level. Nothing special, just a small square, prints quickly. The indicated "L" points to the lower left corner. Makes it easy to identify orientation after you removed the print. Different…
With the 360 degrees rotatable head from my Singer 29k I often lost the overview in which direction to set the head for the next steps, especially when trying to follow curves/outlines from patterns or patches, so I designed this simple…
To wszystkie aktualnie dostępne wyniki.
