Liczymy pasujące modele…
Comments and suggestions are welcome. It's installed and tested on my Switchwire. I ordered a Biqui Nebula extruder. I remixed the Strealthburner version from Biqu and removed the Filametrix parts. The back fits a BTT EBB36 as per their…
I needed a backplate to mount the Fysetc H36 Combo v2 to my Wristwatch G2 on my A4T. Ziptie Version This version only has a strain relief with zipties. You need two heatset inserts for mounting the H36 to the backplate and two zipties.…
I wanted to use the excellent ERCF Smart Filament Motion Sensor, but I wanted a lower profile, when I mount it to the 2020 extrusion on the back of my Voron 2.4. Therefore I moved the mounting flanges and made the mounting screws M3. I…
I needed to allign two MGN9 (later MGN12) rails on the 2060 extrusion of the Sidewinder X1. I couldn't find one so I made one. Make sure to calibrate your filament shrinkage before printing this. I printed in 3DJake dark green ASA. 80 mm…
The daylight on a stick version from Alchemy3d (https://alchemy3d.de/products/daylight-on-a-stick-1?variant=503377434708) has a different hole spacing then the standard version and it's not symmetrical. So I made a version for it.…
This design is inspired by I completely remade this, because I wanted better printability with less bridging and a different fan mount direction. One of the fans is flipped, so that hot air from above the MCU is expelled. I also wanted to…
I needed a mount for a Omron D2F-5L as a Y-endstop for my Sidewinder X1 to Voron Switchwinder conversion. I couldn't get the old inductive endstop to work and I still had a D2F-5L laying around. You'll need: 2 M2x10 Self Tapping Screw for…
Well, I bought new bed fans and didn't look closely at the listing. I got the "new" GDSTIME 5015 fans with 8500rpm. They have a different, bigger air outlet and makes them incompatible with the existing "The Filter" variants. The listing…
I modified jinetix ' mount of the Nevermore V6 for the Sidewinder X1 / the Switchwinder (Sidewinder Voron Switchwinder mod). Blocks the SD-Card slot which isn't functional in my case… Printed in 3DJake dark green ASA. I Should have…
I needed front flat mesh skirts for my 2.4 300mm. I couldn't use the existing version because of the clicky clack door and the BTT HDMI5 I wanted to use. You need to print the parts like it is described here: adjust the modifier in the…
The back panel and foam of my Formbot kit had a different thickness (4.5mm) so I remixed the base pieces. If you need even more you can change the fusion parameter "height" to your desired thickness.
I made a magnetic soap holder for a bar of soap heavily inspired by https://www.printables.com/model/1204297-rectangular-soap-holder-with-magnet-and-adhesive-s I made this for three 10x4 mm round magnets, because I disliked the holding…
I needed a few more of these spacers. I ran out, just before finishing and ordering another bag didn't make much sense. These space your deckboards up 6mm off the rafters below and they space the boards 7mm apart. I just modeled these…
Snap fit lid for Adafruit HUSB238 breakout
I wanted to keep some additional rolls of labels with the Niimbot D11H, but I didn't want to use Gridfinity. So I made an inlay for the original box. I was inspired by this one: You can keep 4 rolls and the USB charging cable.
To wszystkie aktualnie dostępne wyniki.
