Liczymy pasujące modele…
No more dropping your vape and having your battery break off and fly across the floor! Print settings: layer height 0.28mm, no supports, 3 walls The bridge on the top of the window is a bit long, so it might droop. I hit it with a torch…
The waste chute is extra long for a waste bin on the left side of the printer. It was designed to be easily installed and removed without needing to fully unscrew it. I have my printer against a wall and the chute going behind a desk, so…
No more dropping your vape and having your battery break off and fly across the floor! There are three sizes for the newer Off-Stamp vapes. These sizes cover the Classic Cube, Sweet/Ice Cube, and Crystal Cube. Model photos were printed in…
Added additional material on the top where the original is the weakest and beefed up with a few fillets. Used normal supports. Printed in ASA with 0.28mm layer height on AnyCubic Kobra S1. Modeled with OnShape.
Stronger and beefier than the original (since Kingsong reused the wire type support on both sides). Provides good clearance from the wheel. There is plenty of extra room to make it larger, so I will redesign it if there are any issues.…
Top cover that was epoxy/super glued to the original rubber cover. The tab on the original cover easily detaches from the cap. Makes it easier to take on and off. I will redesign if the glue does not hold up over time. Printed in ASA with…
To wszystkie aktualnie dostępne wyniki.
