Liczymy pasujące modele…
Case for Pi3B+ with 5inch DSI display. May work with other Pi models, but I don't have the equipment to try it out. Hardware required: 6x 8x5mm magnets. You could get away with 4 magnets too. 4x M2.5x10mm screws, or use the 2 provided…
I loved DeSteiner's 1887 shotgun. Printed two sets of them, however looking at the remixes for the shell they either need gluing, or filament swapping which is fine until you drop the shell and it breaks. The glue didnt work for me…
Wanted to install smart switch for the kitchen, realizes that wall socket is shallow and cannot accommodate the switch rear, whipped up a design for it. This model provides 15mm spacing and can be adjusted according to your spacing needs…
Uses existing left side extruder to stepper casing for mounting, as right side screw will collide with the idler arm. I tried the original model and the right side will just break if you try to screw it tight. You will need to glue the…
Airtag Keychain with 3x3 round magnets, and optional rear case with 6x3 embedded magnets to attach to metal etc. Required items: 3x3mm round magnets - 6, 9 if you're printing the optional rear case. Optional - 6x3mm round magnets - 3 for…
Car air cond vent broke, need connector, designed it, printed it with PETG, you're good to go. STEP files included if you want to mod it. No commercial selling of this pls. only for personal use.
Took a picture, traced and modeled in Solidworks for cheap knock box damper. Mine wore out after few uses due to soft material used, so made one in 95A TPU with 75% infill. No supports required. Print flat side facing down. Image attached…
I bought an Android carplay adapter for my car, and the stock case was suffocating the module and overheating it which causes it to disconnect and reconnect during long drives. So I teared it apart and designed a new case for it with some…
To wszystkie aktualnie dostępne wyniki.
