Liczymy pasujące modele…
The gun elevates and rotates within the approximate range of the actual gun. I don't recommend any raft or brim. All the holes and edges will require some trimming. See photos for assembly. The assembly begins with the base 1. Attach the…
Sd.Kfz.8 Half-Track. All the pins and holes require some filing. The photo shows it towing a PaK 40 75mm. Most sources say it was used to tow a heavier gun. The new modified front axle 8, steps 9 and rear panel plug into the chassis A…
Nothing terribly difficult about assembly. Need to print two .30 Cal MGs.
The gun moves up and down and rotates approximately with the same range as the real gun. All holes and inserts must be filed clear of any flash/brim/support material. Most parts are friction fit, but some need to be glued. Assemble using…
World War II DUWK Amphibious Vehicle based on the “duce and a half” GMC truck. There were many versions of this vehicle and I based the design on pictures, so I have no idea whether it represents a correct configuration. Most parts snap…
This half-track model is very similar to my published model of the Sd.Kfz. 8. That model is approximately 1/45 scale, I used the same basic chassis, so this one is a 1/42 scale. If anyone intends to print both and have them side by side,…
To assemble, insert half of the howitzer turret from the top into the hull, then the howitzer gun goes in from the front. Follow that by the other half of the turret from the top. Next the turret bushing. The top deck and finally the…
M7 Priest 105 mm howitzer motor carriage. Made from photos, this represents an early version. Any attempt at scale is simply a guess, but the vehicle is approximately 1/60 scale. The gun turns with a small carriage generally representing…
The soft top takes a little sanding and superglue. I put the seats into the print. I trimmed the wheels to make it easier to install the tires. I was never happy with the windshield so I redesigned it. However it required changing the…
Gun emplacement based on the Longues-sur-Mer battery. It is not intended as a scale model, but as a similar casemate site. According to Wikipedia, the guns used at that site were 15 cm TbtsK C/36 naval guns. If so, the gun on this build…
This is a terrific model, I merged the splits to eliminate gluing the chassis. Redesigned the muzzle brake to put actual holes in it. Not sure that is entirely worth it since it then requires supports which are very difficult to remove.
The original model is a good kit. I wanted to see how it looked with a 76 mm gun.
These components are intended for lego size soldiers. They have keyways to plug them together in configurations. They do take a lot of filament and time to print.
N scale support for Bachmann E-Z track system, with various size legs to enable the builder to construct any size and shape track system. The track grip should be installed at the junction of two track pieces to provide support and…
This is a representation of the acoustic component of a helicopter dipping sonar. It is currently used by the U.S. and other navies. It is designed to be hung by a string, but can be placed on a flat surface. I have included folded and…
This is a representation of the acoustic component of a helicopter dipping sonar. It was used by the U.S. and other navies for many years. It is designed to be hung by a string, but can be set on a pad for display on a flat surface. I…
To wszystkie aktualnie dostępne wyniki.
