Liczymy pasujące modele…
Basic glasses stand that can hold up to three pairs. There are two version: one for narrow glasses that can fold and occupy little space (as the pictures ones); the other for larger frames so that the majority of models can fit. There's…
I have some carnivorous plants that requires demineralized water, which I make trough a reverse osmosis system, and have 5L bottles to store it. Since their openings are quite wide (41mm), I designed these spouts to easily add water to…
Very simple 200x200x15mm egg crate. Nothing fancy, I'm using them in my terrarium to keep my carnivorous plants elevated. I printed it with a 0.28mm profile on an Ender 3 v2, no supports needed.
Warmind Rasputin figure from Destiny 2, a game by Bungie. I design this based on the pictures I found, it's not 100% accurate but, for the size of the print, I tried to include as much details as possible. You can print with your desired…
I designed these simple hooks for the IKEA Grundtal since I don't like the fact the original steel ones move that much and thus, since I mainly used silicone utensils, they tend to come off the bar. This design is snap-fit, but be careful…
Simple tool to help hold the part while painting. This can fits both miniatures or larger figures (where multiple parts have to be printed and then glued) thanks to the double surfaces: one is flat, optimal for miniature painting, while…
When building a the100 printer, I had issue finding an Ender 2 bed or similar, so when I found a very cheap Ender 3 one I decided to install it based on the mod by overgo. I had to make some changes: my the100 version has only two rods in…
Very simple card suits buttons. The dimensions are slightly different between models to adjust the feeling of them being similar in size after printing. Print them at your best settings, these are printed at 0,12mm on an Ender 3 v2 with…
Very simple model to hold zip bags (I have various size of IKEA Istad ones). There are no special settings for the print, the model is ready to be sliced, choose the desired layer height (I personally went for a 0.32mm layer height) and…
I designed this rack to use with 50ml test tubes, my partner uses it to store paint for figures (specifically, primers). For the assembly, you'll need: - 8x M3 threaded insert (the holes in the distancer are 4,6(D)x6mm) - 4x M3 flat head…
My old house has a ventilation grid near the kitchen table, and it's “conveniently” on the wall facing a street, so that a combination of smog and air pass trough. I designed a simple grid that attaches with magnets and houses a carbon…
It has a larger section where to place a bag (keep it in place with a couple of clips), while the others are meant to separate trash to recycle (for ex. plastics, paper, etc). I printed it with PLA on an Ender 3 v2, with a 0.6mm nozzle…
To wszystkie aktualnie dostępne wyniki.
