Liczymy pasujące modele…
When the printer is used without nylon rivets, the holes add an unwanted escape route for hot fumes (besides the corners - Kapton tape to the rescue). One spare included at no extra cost :-)
A generic, robust boat hull compatible with standard toy bricks. Low-poly design leaves plenty of room on the inside and more space for the imagination (Pirate ship? Space ship? Pirate space ship? It can be anything). A grown-up audience…
Note: The original gear works fairly well in ABS using a 0.25 mm nozzle (rather high layers e.g. 0.15 mm. PLA is not recommended as it creeps under stress. The two-colored print takes ~70 min / unit plus shared wipe tower. Support removal…
sample setup for MMU with 0.25 mm nozzle (there is no stock preset). Printing the large brick with ASA or ABS needs attention to bed adhesion and chamber temperature (as hot as possible, disable print fan) as it warps easily, lifting off…
(Note: 3D-printed objects may require additional steps for food contact e.g. coating). A small bowl colored in a pattern loosely resembling wood rings, designed from ground up for FDM printing at 100 % scale. For best results set a 0.45…
Scripted - ping me for specific geometry. Original design for XRAY M18T. Primarily designed for foaming filament, tested on Siraya AIR TPU: enforce constant speed across the print via volumetric flow rate limit e.g. 3 mm³/s. Friction in…
Test print to confirm that the whole print area is usable without the umbilical getting stuck between printhead and X motor. Note: Size is the nominal advertised area but you need to scale this model very slightly down to allow for tool…
For built-in furniture, wedges are used as construction material to set gaps to walls and ceiling before closing gaps e.g. with acrylic sealant. Especially when angles aren't straight, it helps to have different sizes available. The .step…
!!! Just printing the files will fail. Please note the instructions on deleting unused stud/antistud sizes !!! The challenge in printing interlocking bricks is to get the tolerances right for both studs and antistuds on a given printer,…
A skull symbol as a 2x2x1 "compatible " toy brick for little LEGO pirates. Sample printed in 0.2mm nozzle, ABS. The logo is not flush with the surface (embedded for strength, though), so ironing can be used without smearing contours.…
To wszystkie aktualnie dostępne wyniki.
