Liczymy pasujące modele…
A basic tape dispenser that fits onto a 6x2 Gridfinity base. Also works fine standalone, although you might want to fix it to something heavy if using sticky, wide tapes. Should fit tape reels up to OD 5"/125mm, ID about 3"/70-80mm, and…
Holds the tape measure by the belt clip. The clip can be up to about 1 inch / 25mm wide. Prints in provided orientation without support. Designed for M3 screw, with 7mm counterbore for screw head. I used these M3 printed thread T-Nuts:…
This is an alternative top nut for Laisch's CNC drag knife holder for cheap drag knifes. It mounts directly to an ER11 spindle nose, interfacing with the M14x0.75mm thread and collet taper to give reasonable rigidity. It's also slightly…
To my dismay I recently found a high capacity Toshiba 3.5" HDD didn't fit on the sleds of the Fractal Design Core 1500. I have seen other designs for similar purpose but they used M3 heat set inserts which I didn't have to hand, and the…
Basic holder for Stanley Fatmax Stubby screwdriver FMHT0-62688. Its an easy slip fit from the front, the rubbery overmoulding on the screwdriver provides a bit of resistance. Good for stationary application, probably wouldn't trust it if…
Holds up to 4 smallish pliers. Handle hole diameter 20mm. Prints in provided orientation. Designed for M3 screw, with 6.5mm counterbore for screw head. I used these M3 printed thread T-Nuts: Skadis T-nut mounting system, threaded for M3…
This uses 3 t-nuts to hold an Ikea Tertial to a Skadis board. The axis of the holder is angled so the lamp arm doesn't interfere with things on the Skadis mounted above, but this causes the arm to rotate under gravity. An additional M3…
Prints in provided orientation without support. Designed for M3 screw, with 6.5mm counterbore for screw head. I used these M3 printed thread T-Nuts: Skadis T-nut mounting system, threaded for M3 or UNC #5-40 screws By ORM You should also…
To wszystkie aktualnie dostępne wyniki.
