Liczymy pasujące modele…
Quick printing replacement part, even in PLA they can take a good bit of weight. These would be a bit stronger printed in 0.3 instead of 0.2 and with more infill, but if weight is that critical, your probably better off ordering metal…
Printed in PLA, with 33% infill this is a very sturdy picture hanger. Attach it to drywall with a common nail up to 2.5mm in diameter (13 ga.). The fine detail in the center also makes a good test to show how acceleration, jerk,…
This is a simple and lightweight hand vise. Just twist the handle to tighten or loosen the grip. Made out of PLA, it's strong enough for many uses, but using a stronger and more heat-resistant material for the arms and cross bar would be…
Most lawnmowers, and a lot of other garden equipment, work best when the blades are sharpened to a 30-degree angle. With this gauge, you no longer have to estimate--just grind or file the blade's edge until tip just reaches the center of…
My HP-11c from the 80's is still going strong, but somewhere in the last 30 years or so the battery cover disappeared. With this part I no longer need tape over the battery compartment. Print Settings Printer: flsun prusa i3 Rafts:…
I saw a full size lathe that had a built-in holder for the chuck tool, and I thought that was a good idea. Rather than mount something more permanent, I designed this holder and epoxied a neodymium magnet in the bottom. Print Settings…
I wanted a lightweight hook I could take along kayaking that could easily snag a drifting boat. I also wanted something that could use to lift outdoor furniture from ground level to a second-floor deck without carrying it through the…
I've been using this PLA filter , but why settle for a boring cylinder? There is a slot in the bottom where you can insert a piece of sponge that has a light coating oil. Almost any cooking oil can work, but I'd check to make sure the…
General purpose right angle with a 20mm and 30mm leg. I built these for my flsun prusa i3 because its z-axis motors are mounted on acrylic brackets that are not rigid enough and needed more support. Edit: I've made a more customizable…
I like to keep all my aviation-related records and other paperwork in a looseleaf binder. Rather than keep my logbook in a separate pocket, I printed out this holder. The logbook stays in place when the folder is closed, but it's still…
I needed more clearance in the y-axis, so I remixed a y-endstop bracket that was 10mm shorter. I don't know if this works with the stock part cooling fan, but I replaced that with a 50mm blower that slides below the rear 20x40 horizontal.…
The arms on the Saitek / Logitech throttle quadrant are easy to break at the point the arm enters the main box. Replacement parts are unavailable, so this is an alternative. It doesn't replace the whole arm, but if you cut back the broken…
To wszystkie aktualnie dostępne wyniki.
