Liczymy pasujące modele…
Modular Case for an Intel NUC11. Lost track of the various Intel NUC11 models. It's that one with the i5-1135G7. Without the two USB-C/Thunderbolt connectors. The case is modular. Central part is the board-one. I melted in heat sets there…
No description needed. A small spool that fits 50g filament samples. Inner diameter is 50mm, should fit most spool holders “spool light” is very slim, uses about 10g material. Outer diameter is 100mm, 13,5mm height. I use this mostly for…
A pine tree, based on the idea of various other models, but (imho) improved and also made ready for two material printing, so the trunk can be printed out of brown material, while the leaves become printed with green material. Print…
Should fit to various oven models that use a ~6mm d-shaft.
Wasn't satisfied with other premade models i found so far. Wanted it to hand the spools in a 90° angle to the wall, so that i can fit more spools in tighter space. Goal was to be able to easily swap between different spools, so no screws…
The whole project is based on and of course compatible to the “sprinkler rocket” by Sevro from Makerworld: https://makerworld.com/en/models/1370364-sprinkler-rocket The rocket shown in the picture is the slim-rocket from there. I wanted…
Heightmap of europe Resolution should be enough to even print with like 50x30cm. Variant 1 surface with plate : Base plate at sea level. Use this if you just want the land area or just want to paint the ocean area. Variant 2 : Add…
I was looking for a solution how i could organize/stack those cases in which different build parts (screws, nuts, resistors, transistors, sealing rings, …) are shipped in. Haven't found any prebuilt solution so i made my own one. Looks…
The box contains mounts fitting three injections with 20ml, 10ml and 5ml (asymetric outlet). Fill the injections with bank notes. Put some transparent sheet into the cover (just glued). Glue some decoration on the cover. I also put a…
Remix of the cover from this remix: https://www.printables.com/de/model/264191-dial-mod-for-beercounterv4
A case for a Wemos D1 (ESP8266) including a (selfmade) shield with any sensors and a 3x AA battery case (https://www.amazon.de/gp/product/B087NMQX4V). Just print it twice and put one on top of the other and screw it together with wood…
Fitting for those sensors you can see in the images
You also installed the original spoolholders and then found out they are "not good"? Then you also struggled even more to remove them again, fearing to break the whole sidepanel of the printer? You searched for alternatives, but they all…
Holder that can be mounted onto aluminum profile and in my case hold LED rails to light the print bed. Used on a Sovol SV04 but should fit on other aluminium profile builds as well. I intentionally just put some holes at the ends and…
After litres of milk ended up in the drip tray because i didn't pay attention to place the cup far ahead enough, i made myself a little helper. It snaps into the cover of the drip tray and the cup side is 81mm in diameter, fitting my 80mm…
The lid was designed for glasses with inner diameter of 46mm. It may fit up to diameters of 52mm, but i haven't tested this. The handle is this here: https://www.amazon.de/dp/B0BCDNJTY1
Dual purpose box for the game cards. Both for storage and actual playing. Since BotG is played with three separate stacks, this keeps the stacks separated and labeled. So no more confusion which stack is which era. For storage the print…
Storing small items but being able to block one half while pouring out.
To wszystkie aktualnie dostępne wyniki.
