Liczymy pasujące modele…
I printed this in Red ABS for gifts to my senior friends who are always dropping their picks. Ha. It will stand on the bedplate on its back end and print well. I then hung it in a jar for a while with Acetone until shiny and smooth. It…
It was printed open side down in tough PLA but would work fine in other materials. Supports on baseplate only. It works for my filter but it might not handle excessive torque.
The Lower shield was printed in red ABS with the added design support to prevent warpage. The Tag base was printed with red filament and the letters in silver. Shield was printed upside down as shown. Then it was heated with a Heat Gun…
I printed this in PLA with the disc flat on the baseplate of course and no supports. The rod is 9-sided and holds good in a 3-Jaw drill chuck.
I printed this in PC, but it could be printed in various materials. It fits close to the Volume and Pickup Knobs and takes advantage of existing screws. Option #1 is original, and Option #2 is a modification recommended by the creative…
This was a gift for my artistic sister. It is a fairly large palette (15"x19.5") with 48 wells and 8 mixing chambers. Due to its size, it was split into 4 quadrants, all printed separately on a Prusa i3M3 in PETG, and then glued together…
Print this in Nylon (nice soft surface feel). Stand it up vertical on one end with supports from baseplate only. The wavy inside coutours tend to contain the knot in the Theraband so it doesn't slip out.
A standard 1” sch 40 PVC pipe will fit snug in the top-end recess-fit. If the fit is exposed to air, you can also secure it to the pipe either permanently with PVC solvent, or temporarily with duct tape to prevent air leaks. The (12)…
Two 3mf & STL files each included for the Light Shade body and Top. The body is printed with 1 perimeter using the spiral vase option, but that makes the top too flimsy for supporting the screw pressure when assembling in the Fan base.…
I printed these Holders in ABS and glued one straight-version to the back wall of my 3D enclosure and 2 Angled-versions to the sidewalls. They do a good job of retaining the gages and are very accessible when the battery needs to be…
Two parts (housing & cap) were printed together in PC-ASA at 270/110. Used 100% infill and supports on buildplate only. The bulb metal hse slips into this housing and the cap is glued on. This was a big improvement to the old yellowed…
I made this in PC TPE which is flexible enough to stretch around the 8oz bottle of hand sanitizer and fit into the cup holder. It printed fine. I keep it in my car cup holder. I usually notice to use it when I come out of a store or…
This Necklace/Earring set was printed at .1mm detail in generic ABS on my Prusa i3 MK3S+. Both the STL and Prusa 3mf slicer file are included. I used 2 perimeters with 8 mm/s travel at small radii. It was printed solid (1 set on the…
I printed this in PETG and it has stood the test of time. STL is attached. Make two of these and screw them to the floor with one screw each. There is enough clearance in the part to allow the front of the chair to be raised a little for…
I printed this in PETG. It almost filled up the bed plate lying on its backside. I painted it and screwed it to the wall… then connected the openers. Most materials are probably fine. I also included an extra opener housing that can cover…
3D‑Printed EV Charge Cord Cradle in ABS with typical settings (flat end mounted down on plate): This Cradle mounts around a 4" OD steel garage support pipe to keep EV charging cords tidy, accessible, and out of the way. The long cords…
To wszystkie aktualnie dostępne wyniki.
