Liczymy pasujące modele…
This small FPV camera is usually meant to have cool air passing by it when mounted on a RC drone or plane. I wanted to mount it on my RC crawler and had a 30mm fan in my leftover electronics box. Center distance of the fan holes is 24mm.…
OnShape Link Currently the model is split up at the main points so that it could be printed on my Bambu Labs X1C. There is room in the upper and lower frames for 8mm x 2mm circular magnets. The exhaust hole is setup to be allow 5.9 inch…
(Work in progress, go to OnShape for latest designs) OnShape: https://cad.onshape.com/documents/681d339b3385a03b7c82fd40/w/77c29d5f0b7b6c4892b4e7f8/e/ce5db72bdc0fc73ead5e2c25?renderMode=0&uiState=656d117cd0c5750e70593629 GitHub Link:…
Drilled a hole through the horizontal part to attach to a rover build. Herelink v1.1 suggests having the antennas at a 15 degree angle. OnShape Link
It works for front and rear suspension. I made this to replace all the stock shocks when I was adding weight to the car so that it doesn't bottom out and scrap the ground. This should work with the original shock screws that connect it to…
Remixed from a design on thingiverse. The original didn't have a center piece that fits well with Sunlu filaments. This acts as an adapter to help balance the Sunlu spools.
With the new popularity of these being used to run agent harnesses like OpenClaw, thought this would be fun to build. The original design workflow is located on OnShape if you wanted to copy it there and modify it yourself. OnShape:…
I have seen some of these aftermarket fender-extenders and (it is my opinion that) they are WAY over-engineered. Axle mounts and the extenders and all that seemed a bit ridiculous. I designed this to be printed in one piece and use the…
To wszystkie aktualnie dostępne wyniki.
