Liczymy pasujące modele…
There are clones of the WAGO lever action terminal blocks on AliBaba, Amazon, and other stores that have a different mounting system. In order to mount these on a DIN rail, you will need this “push to lock” style mount. Print at .2 to .3…
There were no small, or skeleton cases on Thingiverse for the Pi 4. I grabbed a set of calipers, and designed this case for it. It is specifically designed to hug the dimensions of the case very board tightly, and only requires four M2 x…
This is a shim to print and place under your batteries in the Megacell Charger ( Batch 1 and 2 ) ... it prevents 18650 cells from rocking and making bad contact due to the small temperature sensor that is located just under the cell. No…
My Pentair pool control box latches broke after a decade in the sun. The part of the latch that broke would require a $50 part to repair. Not if you have a 3D printer it won't. I measured the part and created a new one that should fit the…
FoldRule: a geometry set that folds into a pocket FoldRule puts a 160 mm ruler, a 180 degree protractor, a compass and a set of circle stencils on one card. It prints flat in a single piece and folds down to 72 x 60 x 7.6 mm, small enough…
These designs will work for CupCake serial number 100 and up. Videos of the TwoTimes LowRider: TwoTimes designed the X/Y LowRider, and then vanished from the internet. I have re-uploaded the files here, to make sure at least one copy…
This is the mount for the display control boards at PDX hackerspace
To wszystkie aktualnie dostępne wyniki.
