Liczymy pasujące modele…
The ergonomic thumb recess provides much better control , helps keep your fingers away from the nasty, sticky stuff in the tray. Has a left (LH) and right-hand (RH) version, A right-handed person will normally use the RH tray in horizonal…
These objects were fitted on a 2022 Chevy Colorado. They should fit all “Generation 2” 4x4 Colorado and GMC Canyon trucks. There are two versions: Note that the 4x4 Knob Lock object is different in each version and NOT interchangeable.…
Works with most sockets and bits with a ¼" hex shank. You can throw these into your toolbag and the tools will stay in place . Includes two versions. This should be printed using TPU filament; flex is important here. As typical for a lot…
A three-piece bracket, one mounts on wall, the other two bolt together around the 25mm/1” shaft. The shaft part has a lanyard loop that can be used with a shoulder harness. Max print size of largest object is 70x125mm on the x/y axis and…
A switch guard/shroud designed for the dashboard mounted winch switch on the Kawasaki KRX 1000, but can also be used on some of the other dash switches as well. Its purpose is to simply reduce the chance of accidental activation and…
2026-May-20: I added a 2 wire, 3 wire and 4 wire comb object. 2026-Apr-23: I added an additional style (B version) of the center loom. It's designed for wire routing OVER the rear of the valve covers. This new style does not need the…
This remix improves on a design by Paul Cangialosi - https://5speeds.com - (YouTube: GearboxVideo): https://www.youtube.com/watch?v=5Rv_cO6Edu8 This model should be printed using a rigid filament. It can be printed in PLA, but 4…
I was disappointed that Shark did not include a comb type adapter with the WandVac we bought. This adapter for the WandVac was designed for rugs and carpet where organic debris (leaves, etc.) might be more prone to get trapped into the…
Typical PLA printing works fine for indoor use at 15 or 20% infill (I prefer Gyroid) and 2 or 3 perimeters, which will use about 60 to 70g of filament. This model prints mostly on the x/y axis. Max x/y axis size: 83x120mm. Max z axis…
Published at the request of someone on the ColoradoFans truck forum. https://www.coloradofans.com/threads/phone-mount-that-doesn%E2%80%99t-block-vents.439522/ . I did the design 3+ years ago, then revised for my current Pixel 7 Pro. I…
To wszystkie aktualnie dostępne wyniki.
