Liczymy pasujące modele…
I have a unique space and I wanted something to “holster” my M12 installation driver on the underside of a shelf above my standing desk. Most options I could find were wall mounts. I printed it with minimal supports standing up. Due to…
I designed these to snap fit into the second groove of the top of the fixture. The print 3MF is oriented in the file stand up on its edge so that you can scale your Z height to the length you'd like to print (or your printer can handle).…
These clips are included with the Govee icicle lights, but I don't imagine they will last many seasons (especially in Arizona sun). Rather than order a bunch from Govee I figured I'd model one and print some in ASA.
I recently build an LDO 300 Trident with a Cartographer probe and wanted to use the decontaminator bucket/arm. But since they recommend using a silicone brush from Bambu (for obvious reasons) I had to modify LDOs model to raise the…
This is a small arm designed specifically for 8mm glass rimless aquariums. It uses two M4x4 heat set inserts to mount to the back of the AI Prime mounting arm. I designed this because I noticed the clamp can tend to tip if bumped hard…
This is for the AI HMS rail system to allow mounting of an AI Prime HD fixture. You'll need an M5x12mm socket cap head bolt (stainless preferred over saltwater). Print settings - Filament - PETG Layer Height - 0.2 Infill - 50% Gyroid…
While I'm sure it was fine, the idea of metal on glass made me uncomfortable, especially under a clamping load. I also noticed there's potential for water to find its way out of the tank via capillary action and I wanted to prevent that…
Frustrated with how bright the light ring is on my Anker 623, I decided to print a base that blocks most of the light. Mine is in my bedroom, where I sleep… how this was thought to be a good thing is beyond my understanding… I designed…
Simple clip that snaps securely to HMS rail for cord management. There are two smaller and one larger hole to accommodate varying cord diameters (2x5MM 1x6.5MM). If you need other sizes, I'd be happy to try and modify the F3D file.
While I'm sure it was fine, the idea of metal on glass made me uncomfortable, especially under a clamping load. I also noticed there's potential for water to find its way out of the tank via capillary action and I wanted to prevent that…
This is a bracket that slides onto the HMS rail system to hold a Hydra 44 Edge fixture. Print one for each side. Could work on larger Hydra Edge fixtures, but I don't have one to verify. Requires - (2) M8x1.25 x 12MM cap head bolts Print…
To wszystkie aktualnie dostępne wyniki.
