Liczymy pasujące modele…
A rugged box/case to store your USB endoscope camera (soft or rigid cable) with a pocket to hold the accessories like 90deg mirror, hook, etc. You will need 6x M3 30mm screws. No brass heated insert is needed. Print 1x Endoscope Lid.stl,…
Awesome design, but I didn't get a good thread engagement with the tick gasket I was using, so I increased 2mm on the height. Use nylon filament, since even ABS/ASA will be “eat” by the brake fluid. No, I do not share the design files.…
Usually you find clutch alignment tools for N54 when the pilot bearing is inserted to the flywheel, but my E89 Z4 has the pilot bearing embedded to the gearbox input shaft, that means the flywheel has a center peg/pin to support the…
The original restrictor disk has a passage of 13mm, too small for some type of beans. This new design has a 15mm opening and an extra 3mm wall to catch the beans. I've used PETG filament with just one wall and half of the height as bottom…
These ChaoticLab hinges did not fitted well to my extrusion profile, it kind twisted the door leaving a huge gap from the door to the extrusion. This model will replace the M3 T-nut to a M3 brass heat insert (3x4x5mm). Use ABS or ASA…
Use a rubbery type filament material, like TPU or TPE. Fits snug to the bottle and does not fall off. No, I do not share the design files. Use at your own risk.
I use small espresso shot cups, and using the scale over the Puristika's tray is a very high drop from the portafilter. I've created this model to get the scale a little bit closer to the portafilter and don't get all the cabinet painted…
MHW-3BOMBER Espresso Shot Mirror isn't magnetic to hold to the machine by itself (and even the Puristika does not have a flat surface large enough to install it), so I created this model with 6x magnets (6x3mm) that can be press fitted to…
Here is a tray to keep your E-Torx Ratcheting Wrench tool kit (GearWrench 9224D) organized. Use a rubbery type filament material, like TPU or TPE to avoid scratching the chrome. Change filament color after 35mm to get contrast and easy to…
A friend has a Varia VS3 coffee grinder that doesn't come with a rubber bellows to purge the grounded coffee from it's chamber, so I've made this design. It is still to be tested. Use the softer/rubberish material you have, it will be too…
This pressurized brake bleeder kit comes with a tool to release the filling cap, but not a tool that can release the pump assembly. To make the cleaning process easy, I designed this tool to unlock the pump assembly, since all the caps…
I own a Skywalker Coffee Roaster, the opening to load the coffee into the chamber is kind of tiny. I designed this tray to make the roasting process a little bit easier. If you want, there is a filament color change on the last couple of…
To wszystkie aktualnie dostępne wyniki.
