14 modeli
After a few years of use the dustbin was not latching to the vacuum cleaner and this rendered the vacuum cleaner useless( sensor detects whether the dustbin is properly closed). At first glance the part could be glued, but this was only a…
Wydruk około 1,88 €–2,30 € nettoWstępna wycena jednego wariantu
I modeled this to replace the worn out hexagon portion of the Neato Botvac that seems to tear up on every vacuum. I printed mine no supports, but on a raft just to make sure the gear teeth came out clean. I have about 6 months of runtime…
Wydruk około 0,43 €–0,52 € nettoWstępna wycena jednego wariantu
Update: I've added a version that includes grease channels to help retain more grease. This drive gear replacement for the Neato Botvac D7 is bolstered to ensure it is strong enough to withstand the forces the beaterbrush gives it. The…
It's a remix of the original with no support needed. https://www.tinkercad.com/things/fxlI4BvneEF/ Category: Household Supplies
I printed it in PETG for durability on the Satin print surface of my MK3S+. The not completely smooth finish gives it apparently enough grip, such that the robot vacuum can drive up on it. The 150mm width is chosen for compatibility to…
This latch solves the issue by forcing the lid shut. Put a tape on top of the flat surface if it is not tight enough.
I really liked the original, there were only 2 things I changed: I turned the designs 180 degrees so it's much easier to print The squares with rounded corners do look really nice, but my printer was not happy with it. So I made the holes…
Description Neato Intake and dustbin holder spare part. Made this from measurements of original part. Some differences exists but its mostly the same. Print instructions I printed this in PETG Prusament and have not had issues (yet) with…
Shorter than usual models (25+100mm) In download pack STL + DWG (for changes if it needs) UPD_Rev01: pin connectors 0.5mm less for easier pulling into next modul
During operation of the botvac, dust accumulates in the filter and ultimately blocks the air flow. The filter is waste and must be replaced. Using the adapter and a hoover, the dust can be sucked out of the filter, thus extending its…
This is just a small leaver to help pop-out the filter in the dust bin. Hope you like it! Print instructions Prints well in both PLA anf PETG
This is a model I created many years ago. a few weeks ago, I decided to start revising the model into something new. this is the second revision of the model (first one on my profile) and it turned out greater than i expected. and the…
here is a revision of an old model i made. it has better printable parts, with a better fitting dust bin. many more revisions will be made later on so check out those in the future! warning: scaling the model may mess up how the dustbin…
Robot Vacuum Ramp – 2.2 cm Threshold (10° Incline) My robot vacuum kept stopping at my room's door, which meant my room was always the one that stayed dirty. It was finally time to do something about it. So I designed this modular ramp…
