Liczymy pasujące modele…
This is an adapter made to suck dust from my Makita DHS680 circular saw with a shop vacuum. opening is 38mm in diameter. Print Settings Printer Brand: Creality Printer: Ender 3 Pro Rafts: No Supports: Yes Resolution: low Infill: 25%…
osVAC Connector for my Makita MAKITA DHS680 (US: MAKITA XSH03). It is a remake/mix to fit Makita and the osVAC Connectors. Update 2022/05/29 V5 More Material for the screw, because i've cracked it after a few uses with a long hose of my…
Update: I have improved the design. The revised assembly can be clipped or pressed into the original bearing mount. The connections are dimensioned as a light press fit, so a small amount of force is required for the assembly to snap into…
The stock Sovol SH03 spool support has a very wide bearing wrap angle (~123° for a 200 mm spool), which causes the filament to bind and jam — especially with smaller diameter and cardboard spools. This lodgment set significantly reduces…
I can't mark it as a remix of a model from Thingiverse but this is a remix. Designed to fit #8 wood screws. Based on https://www.thingiverse.com/thing:5240190 by Brodo78 The original runs all the way down the shoe of the saw and it felt…
I purchased my Sovol SH03 dryer and noticed that there are vents on the bottom and was not happy with those being so close to the table. I also found about a dozen SH02 models for risers, but found none for the far beefier SH03, so I…
This is a riser for the Elegoo Centauri Carbon 2, with the intent to mount a Sovol SH03 on top. The bottom part could also be printed on it's own and combined with other top holders. It grabs the CC2 from the inside and outside edge, so…
I needed a mount for a Sovol SH03 filament drier in my new printer cabinet so that I could have the drier on a drawer made of some aluminum extrusion. This mount matches the underside of the Sovol SH03 4 filament drier perfectly, allowing…
At first, I simply put the dryer on top, but I realized that the roof was bending and the dryer was moving due to the printer running. I then bought two 455-long profiles and created this simple stand. The stand fits over the profile and…
At first, I simply put the dryer on top, but I realized that the roof was bending and the dryer was moving due to the printer running. I then bought two 455-long profiles and created this simple stand. The stand fits over the profile and…
This is a remix of the bearing mount by Schau: In my case the pieces wouldn't stay togehter. Therefor i connected them. The strip between the bearing holders is only 0,4mm thick, so it can go over the lid of the desicant comartment. It…
The Sovol SH03 filament dryer is a 4 spool dryer with 2 independent chambers. Each chamber has a compartment on the bottom to hold desiccant bags. I wanted to use loose pellets so I made this box which fits precisely in the compartment.…
