Liczymy pasujące modele…
This is the rubber grommet that the front grille on a Corrado inserts into on the radiator support. It may also work on a G60. I printed it in TPU, 100% infill. I am not sure how long it will last but it fit well. Photo shows the original…
As the the mounting points of the rear sway bar are not good enough (IMHO) I designed a holder which seem to function perfect and is easy to install and print. I used M3x16 screws to mount the holder and the shock tower to the body. For…
Updated design from the following research project: https://journals.plos.org/plosntds/article/file?id=10.1371/journal.pntd.0011899&type=printable Assembled with the following parts: Body screws:…
Variation on the standard mosquito dipper, designed for a 16mm (5/8 inch) wooden dowel. Inset in the dipper cup is an area to hold your vial while sampling. Category: Other
i wanted to use existing SW-Motech Legend Gear side-panniers but there are no fitting racks for the BTM Wildfire on the market yet. So i made my own. Disclaimer: these need to be strong! Really, really strong! Using PC-CF wasn't enough on…
Print two normal and one locking pin per bag. Use the template to figure out where to mount them with countersunk screws. I printed all parts in PLA+ with 100% infill. So far they are holding up. Thanks to @Robin for the pins and spacing.
Note this works for the USB-C (short, non pro) version, like this one: Aliexpress Required hardware: 4 x threaded insert M2 4 x Screw M2 countersunk 1 x DSUB-9 connector Printing Instructions Pinted on Babulab X1C 0.16mm optimal profile…
Staubschutz für die Okularseite. Einfach raufdrücken - hält von selbst. Dust protection for the eyepiece side. Simply press it on - holds by itself.
Assemble using a 1" conduit clamp, fan and motor equivalent to the John W. Hock part #4.10 Category: Other
I lost my lens caps to my Swarovski SLC 8x30WB binoculars, so designed and printed replacements using Fillamentum FlexFill TPU 98A on Prusa Mini with 0.6mm nozzle and 0.2 layer height with 30% infill (not that it uses the infill at all).…
Alternative to commercial mosquito traps. Assemble using a 1" conduit clamp, fan and motor equivalent to the John W. Hock part #4.10 Two part epoxy to bond the upper and lower sections of the trap after fan/motor installation. Print…
Tiara with hashtag #SLCPBR (Software Livre Campus Party Brasil) for use in event ;) Category: Accessories
Note this works for the USB-C (short, non pro) version, like this one: Aliexpress Required hardware: 4 x threaded insert M2 4 x Screw M2 countersunk 1 x DSUB-9 connector Printing Instructions Pinted on Babulab X1C 0.16mm optimal profile…
Tiara with hashtag #SLCPBR (Software Livre Campus Party Brasil) for use in event ;) Category: Accessories
This is A redesign of my Original that I had made in wood. I made it Easier to print on most 225 + print beds. If printed from the existing 3MF files no supports are needed and can be printed on the plate. The Alignment pins are not…
Printable door for Allen Bradley 1747 modular CPU's. Printed with eSun Silver PLA for a near perfect colour match. I would recommend a 0.1mm layer height.
