1 / 6
Cat Back Scratcher
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Cat shaped back Scratcher with ball of yarn grips.
You will need 2 piece of cord 50cm long to tie together. I used 1mm cord but hole is 2.5mm
Design in mind for limited mobility people as it goes over shoulder and down to side, the balls of yarn are also easy held in palms.
*NOTE* Claws may need light sanding depending on the print I had 2 which had some stray filament from nozzle which was a bit too sharp.