XT60 Connector Safety Cap
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.15 – €0.18 net (excluding VAT)
For file: XT60 Cap v3_0.6n_0.35mm_PETG_MK3_10m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.16 excluding VAT (range midpoint).
- Weight reported by the author
- 2 g
- Print time reported by the author
- 10.2 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Friction fit cap to go over male XT60 connector ends (e.g. LiPo battery leads) to prevent shorting the connectors.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 142
- Makes
- 1
- Views
- 699
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
Simple friction-fit cap for XT60 connectors. I print in PETG with a 0.6mm nozzle. If you're using TPU you might want to scale it down to 0.95–0.98 to get a little extra snug on the fit. Has a slight taper on the end to make it easier to line up.