Vertical Open Knife Holder Gridfinity box
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.83 – €3.46 net (excluding VAT)
For file: Vertical Open Knife Holder_0.4n_0.2mm_PETG_MINIIS_3h6m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.15 excluding VAT (range midpoint).
- Weight reported by the author
- 43 g
- Print time reported by the author
- 3.11 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Gridfinity 1x1x12 box for holding open knife, 7cm long blade
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 10
- Makes
- 0
- Views
- 174
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
About
I have Victorinox Swiss Army Knife with always open knife blade for easy access (and because I can't grow long enough fingernails :) ). Recently I decided to have a decent place for it instead of keeping always open on the table.
I took 1x1x12 pmcquay bin and adjusted by fixing bottom holes for easier print, side holes for magnets, full infill box with a hole through-all box inside for the knife blade.
Entrance to the hole has some edges removed to make knife blade sliding in easier.
Please give a like and post makes and provide comments for further improvements.
Changelog
- 2025.06.08 added version with a bit more off-center hole where knife has more tools (photos with a black box and silver knife)
- 2024.11.01 initial release (photos with a yellow box and red knife)
Todo
- the hole entrance could have a bit of improvement for the knife tip on the shorter side.
Dimensions:
- width: 42mm (gridfinity)
- depth: 42mm (gridfinity)
- height: 12 units of gridfinity height, can hold over 7cm blade
- magnets 6x2mm, optional
- side holes 6mm diameter so you can put magnets from the side, you may need to use a drill to make it easier to put it in, also I suggest putting only 2 magnets from the shorter side, those magnets really help keeping knife in the box and give a slight friction when putting knife in/out
Print:
- notice gcode contains moves for my custom timelapse video capture (print head moves to back and then to Z axis), so provided gcode file is just for rough estimation of the print time + required filament,
- I suggest 0.2mm layer height
- infill whatever you like but 10% is enough
- no supports, no brim