D20 Vertical Magnetic Display
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Vertical display for D20 that uses magnets.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 10
- Makes
- 0
- Views
- 84
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Share Alike
A vertical magnetic display for D20.
You can put them on the magnetic surface you want!
Show your friends your coolest dice and let them see that all the money you spent on getting them didn't go to waste!
SOME INFO REGARDING THE MAGNETS:
The display uses 2 round magnets in the back.
The magnets have a diameter of 10 mm and a height of 1 mm.
To attach the magnets is requiered glue , i used a generic super-glue.
! Remember to check the polarity of them before putting the glue !
SOME INFOS REGARDING THE MODELS:
For combining the “HOOP” and “BASE” models I advise to use a bit of glue, even if the 2 pieces fit together well
The “HOLLOW” models doesn't have the holes for the magnets, the back it's hollowed so you can place the type of magnets that you want. (2 mm deep)
The “SUPPORT” models are in a single piece, the only glue needed is for the magnets, but remember to enable supports!
SOME MODEL'S MEASURES:
The hexagonal base is 35 mm long, 30 mm wide and 3 mm high.
The rim (when inserted in the base) protrudes ± 24 mm for "NORMAL" and ± 25 mm for "NORMAL +".
DICE MESURES:
There are 2 mesures for the model, “normal” and “normal +”(see first image) :
The “normal” option is for dices that have the lenght of the side of a triangle of aproxtimelly 12 mm . (see second image)
The “normal +” option is for dices that have the lenght of the side of a triangle of aproxtimelly 15 mm.
Thank you for reading and have a good day! :)