1 / 3
WLED OBO box holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made this for a WLED setup to control some lights in de garden.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 25
- Makes
- 0
- Views
- 693
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted some LED's outside wired with WLED controller so I needed a case. Had a OBO case laying around so decided to use that.
This is for a 55x137x32mm power brick, it fits in a OBO T250 case and I use a NodeMCU Amica board with a Stepdown module and a level shifter pcb. I used a barrel connector so I do not have to cut off the connector of the PSU.
Print two of the Cable-inlet-230.3mf to guide the power wire thru one of the big holes.
Step files includes for if you like to adjust some things.