LM2596 and LM2596S Buck converter tool-less snap-fit enclosure - Ender, CR-10, 2020
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A tool-less, snap-fit enclosure for your LM2596 buck/step-down converter that should snap-onto any 2020 extrusion…
- Rating
- 4.778 / 5
- Likes
- 99
- Downloads
- 981
- Makes
- 12
- Views
- 3,959
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
A tool-less, snap-fit enclosure for your LM2596 buck/step-down converter that should snap-onto any 2020 extrusion without extra hardware. This enclosure also allows you to keep your wires separate via the outside channels or together in one via the center channel.
A base without the clips is included as well if you would rather use double sided tape or need to attach it in a different way.
Enjoy and post your makes!
If you found my Things useful, treat me to a cup of coffee by using the PayPal button below :) Buy me a cup of coffeeBuy me a cup of coffee $3.00 USDBuy me a massive cups of coffee $5.00 USDGive me a caffeine coma $10.00 USD Update 5: I have added v2 of both bases. This fixes the accidental gap in between layers causing weakness of the mount that holds the board. Should be all good now.
Update 4: I have printed 3 sets of these with the updated tabs. With my recommended settings below, they are much stronger. I have uploaded new photos.
- Update 3: After printing 4 copies of these, they REQUIRE a high infill %. I suggest at least 80%, slow it down to 40mm/s, and do a .1 or .15 layer height. Otherwise, the tabs are hollow and snap off with ease.*
Update 2: Please use "Lid-v2.stl" as I have updated the tabs to be stronger. I would also suggust printing at .1 or .15 layer height for added strength.
Update 1: The tabs on the lid are a bit too small. They are fragile. I will upload a v2 shortly with better, stronger tabs.
Thanks to @enkoopa for the snap on lid idea and @Andys1957 for the converter mounting idea!
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
.15 - .1
Infill:
80%-100%
Filament: CCTREE PLA GREEN
Notes:
Use a high % infill for added strength of the tabs on the lid and in the box.
Post-Printing
Category: 3D Printer Accessories