1 / 5
LED Light Bar
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Use LED's to light up anything below!
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 8
- Makes
- 0
- Views
- 112
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This model uses any LED Strip and any 16/18 AWG Wiring to wire LED's into a neat shape lighting up your next project!
Materials:
- Wiring 16/18 AWG (any length to wire into power supply)
- 1 meter (3 feet) of your LED strip
- 8 M3x6 Heat Inserts
- 8 M3x8mm Screws
- 8 M3 Washers (Use 1 washer on each screw)
- 4 Countersink Head Wood Screws
Instructions:
- Step 1: Print all 5 parts. Each is different, so keep that in mind.
- Step 2: Install 4 heat inserts into each side of the “LED End” pieces. They will attach to the center V piece and the 2 stands.
- Step 3: Attach the 2 “LED End” pieces to the center V Piece. Make sure the channel lines up properly on the bottom, and that the heat inserts are facing the ‘Inside’ of the V shape.
- Step 4: Run your wiring of choice through the channel on the back of the stand. Both sides have this wiring channel.
- Step 5: Solder your wiring onto the LED Strip.
- Step 6: Attach your adhesive backed LED Strip to the flat channel fitted for the LED's
- Step 7: Attach the stands onto the assembled V Shape. Make sure to pull out additional wire slack.
- Step 8: Attach to shelf and enjoy the interesting V-shape LED design!