Door-wreath mounting bracket for decorative ribbons
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.17 – €1.43 net (excluding VAT)
For file: TuerBandHalter_0.3mm_PLA_MK3S_1h10m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.30 excluding VAT (range midpoint).
- Weight reported by the author
- 19 g
- Print time reported by the author
- 1.17 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Door-wreath mounting bracket for decorative ribbons
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 9
- Makes
- 0
- Views
- 134
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
EN:
The door wreath, which we had attached with decorative ribbon, kept coming loose because the adhesive tapes were slowly coming off due to the pull. As I didn't want to damage the door by stapling it, I came up with this device. It works with a Tesa power strip that is attached to the narrow part of the bracket:
The pull should hold the device in place (despite the slightly slanted angle of this door). Attach the strip as shown in the picture
Material: PLA
Layers: 0.3mm
Supports: none
kkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkk
DE:
Der Türkranz, den wir mit einem Schmuckband befestigt hatten, lockerte sich immer wieder, da die Klebebänder sich durch den Zug langsam lösten. Da ich die Türe durch tackern nicht beschädigen wollte, habe ich mit diese Vorrichtung ausgedacht. Sie kommt mit einem Tesa-Powerstrip aus, den man an den schmalen Teil des Winkels anbringt:
Der Zug sollte (trotz des bei dieser Türe leichten schrägen Winkels) die Vorrichtung an Ort und Stelle halten. Das Band in der im Bild gezeigten Weise anbringen:
Material: PLA
Schichten: 0.3mm
Stützen: keine