1 / 5
PB Swiss Tools PB 53 and PB 1100 Precision Screwdriver Holder for Ikea Skadis — image 1
1 / 5

PB Swiss Tools PB 53 and PB 1100 Precision Screwdriver Holder for Ikea Skadis

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A magnetic PB Swiss Tools PB53 and PB1100 telescopic screwdriver holder for IKEA SKÅDIS pegboards

Rating
0 / 5
Likes
9
Downloads
20
Makes
0
Views
273
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Share Alike

This is a magnetic PB Swiss Tools PB 53 or PB1100 ESD telescopic screwdriver holder for IKEA SKÅDIS pegboards. It uses Skadis T-Nuts mounting system for secure, rattle-free attachment.

The holder provides one slot for the PB 53 / PB 1100 handle with a blade inserted and 7 additional slots for PB 53 blades, which is essentially the contents of a PB 515 set.

Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts.

 

Required Hardware

QtyDescriptionSourcing
260x10x5mm Neodymium MagnetAmazon DE
2M2.5x12mm Socket Head Cap Screw  or Button Head Cap Screw **Aliexpress
2M2.5 DIN934 Hex NutAliexpress

** Up to 25mm length is fine too

 

Printed Parts

QtyPartDownload
1PB53 Holderthis project
1PB53 Holder End Capthis project
2Skadis T-Nut M2.5Download here

 

Printing

Print the parts in the original orientation. All STLs are pre-rotated in the right orientation for printing.

  • Material: PETG, PLA, ASA, etc.
  • Extrusion width: 0.4 or 0.45mm
  • Layer height: 0.2mm
  • Perimeters: 3
  • Infill: 15%
  • Supports: no

 

Assembly & Installation

Step 1: Prepare T-Nuts

Insert the hex nuts into the bottom of the T-Nuts. The nuts should fit tightly and not fall out. If the fit is loose, apply superglue cautiously, ensuring it does not seep into the threads.

Step 2: Insert magnets

Push both magnets all the way into the opening.

Step 3: Add end cap

Apply a small amount of superglue to the end cap (as shown) and attach it to seal the magnet opening.

Step 4: 

Push the M2.5 screws into the screw holes all the way and screw on the T-Nuts until there's a gap of about 2mm between the T-Nut and the Holder.

Step 5: Installation

Orient the T-Nuts vertically and then push the whole assembly through the holes in the desired location on your pegboard. Apply light pressure on the screwdriver while tightening all screws. Avoid over-tightening. As you tighten, the T-Nuts will lock in the horizontal orientation.

Step 6: Add tools

Tada!

 

Tags