PB Swiss Tools PB 53 and PB 1100 Precision Screwdriver Holder for Ikea Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A magnetic PB Swiss Tools PB53 and PB1100 telescopic screwdriver holder for IKEA SKÅDIS pegboards
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This is a magnetic PB Swiss Tools PB 53 or PB1100 ESD telescopic screwdriver holder for IKEA SKÅDIS pegboards. It uses Skadis T-Nuts mounting system for secure, rattle-free attachment.
The holder provides one slot for the PB 53 / PB 1100 handle with a blade inserted and 7 additional slots for PB 53 blades, which is essentially the contents of a PB 515 set.
![]() | Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts. |

Required Hardware
| Qty | Description | Sourcing |
|---|---|---|
| 2 | 60x10x5mm Neodymium Magnet | Amazon DE |
| 2 | M2.5x12mm Socket Head Cap Screw or Button Head Cap Screw ** | Aliexpress |
| 2 | M2.5 DIN934 Hex Nut | Aliexpress |
** Up to 25mm length is fine too
Printed Parts
| Qty | Part | Download |
|---|---|---|
| 1 | PB53 Holder | this project |
| 1 | PB53 Holder End Cap | this project |
| 2 | Skadis T-Nut M2.5 | Download here |
Printing
Print the parts in the original orientation. All STLs are pre-rotated in the right orientation for printing.
- Material: PETG, PLA, ASA, etc.
- Extrusion width: 0.4 or 0.45mm
- Layer height: 0.2mm
- Perimeters: 3
- Infill: 15%
- Supports: no
Assembly & Installation
Step 1: Prepare T-Nuts
Insert the hex nuts into the bottom of the T-Nuts. The nuts should fit tightly and not fall out. If the fit is loose, apply superglue cautiously, ensuring it does not seep into the threads.

Step 2: Insert magnets
Push both magnets all the way into the opening.

Step 3: Add end cap
Apply a small amount of superglue to the end cap (as shown) and attach it to seal the magnet opening.

Step 4:
Push the M2.5 screws into the screw holes all the way and screw on the T-Nuts until there's a gap of about 2mm between the T-Nut and the Holder.

Step 5: Installation
Orient the T-Nuts vertically and then push the whole assembly through the holes in the desired location on your pegboard. Apply light pressure on the screwdriver while tightening all screws. Avoid over-tightening. As you tighten, the T-Nuts will lock in the horizontal orientation.

Step 6: Add tools
Tada!

