Front Panel Ikea Lack Table 3 Buttons (with Prusa Logo)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€5.84 – €7.14 net (excluding VAT)
For file: roundbutton_015mm_pla_mk3_7h7m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €6.49 excluding VAT (range midpoint).
- Weight reported by the author
- 68 g
- Print time reported by the author
- 7.12 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
I wanted to have a nice front panel for my Ikea Lack Enclosure with some buttons to turn on the printer, some LED and…
- Rating
- 5 / 5
- Likes
- 249
- Downloads
- 903
- Makes
- 6
- Views
- 12,612
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I wanted to have a nice front panel for my Ikea Lack Enclosure with some buttons to turn on the printer, some LED and the Raspberry Pi.
I designed this really simple front panel with three holes (20mm) for the buttons and on the other side, added the Prusa logo to make it nicer :)
The Switches that I used are from Mountain Switch (Model : R13-135). You can find them with or without the light and also in other colors. I find them on Mouser Electronics and they ship Worldwide.
There is two STL, one for the buttons and the other with the logo. I put the two on the gcode and you can print them together on the same plate.
Modify it as you want and Rate it if you downloaded it :)
Don't hesitate to leave a comment if you have a question and a Make if you made it.
Thanks for the support
UPDATE 1 :
I added some supports on the back of the front panel due to the pressure on the buttons
UPDATE 2 :
I Installed mine with some strong double sided tape and there is enough contact surface to hold the pieces and nothing moves. Everything works fine.
UPDATE 3 :
I made a second version of the buttons side to fit some round M19 switches that you can find here : https://www.ebay.com/itm/1pc-Metal-Flat-Blue-Led-Push-Button-Waterproof-Resetable-Switch-19mm-QN19-C5-/223013789312
Print instructions
Print in 0.15 or 0.2 with the front face down to have a nice first layer.
Use supports from the build plate for supporting the bezels and the holes.
Be patient during approximately 14 hours and don't forget to eat gummy bears and to drink water :)