Big sized LED Lamp with tactile switch

The lamp is using the Bambulab LED Light Kit 001 or compatible to light the big LED. The on/off switch is placed below the big tactile switch, so the lamp can be turned on and off by the switch. 

There are 2x screw M4 x 8mm used to mount the LED body with the LED wires, after the disc of the LED kit was put in-between.

It is also possible to drive the LED with GU5,3/G4/G6,35 12V light source. The adaptor is available here:

https://www.printables.com/model/1133793-led-light-kit-001-adapter-for-gu53g4g635-sockets

Building Instructions

1. Build the LED
   1. Place LED module disc inside the printed “LED body”
   2. Screw the printed “LED wires” with 2x M4 x 8mm to the body and put the USB-Plug and the switch through the wire with a little whole at the end
2. Press all Vias into the PCB
3. Press the LED into the vias
4. Press the switch of the LED Kit 001 into the whole below the tactile switch with the nipple to the top
5. Build the tactile switch
   1. Start with the printed “Bottom”
   2. Press 2 printed “Switch Wires” into the printed “Bottom”
   3. Put the printed “Switch Spacer" into the printed “Switch Knob”
   4. Put the Knob on top of the printed “Bottom” plate
   5. Put the printed “Switch Body” on top of the printed “Bottom"
   6. Put the printed “Switch Metal” on top of the printed “Switch Body”
   7. Fix everyting by pressing the 4x Switch Nipples through the 4 holes
6. Press the tactile switch into the vias

Hints:

Depending on printer and material…

• the M4 screws can be very tight. In this case add some silicon oil for better mounting
• the vias can be loose, in this case add some glue
• the switch nipples can be loose, in this case add some glue