1 / 2
Third Arm For Andonstar AD106S
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Microscope holder and third arm with tube mount or wall mount
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 34
- Makes
- 0
- Views
- 312
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
The holder on my Andonstar AD106S was not enough for me, so i printed this third arm to give me more room. It looks like it might fit other Andonstar models, but don't forget check before printing.
I printed these in PLA+ with a 50% infill for the whole print.
Remember these bolts are plastic… Don't over torque or overload them. Just use metal if in doubt.
The screw holes on the circular part holding the microscope have been designed slightly smaller in diameter . I recommend using a tool when tightening these screws.