Bambu P1S Air Filtration Adapter

An air filtration adapter for the Bambu P1S printer which supports a HEPA filter

Required, non printable, materials for filter and mounting (YOU MUST SUPPPLY THESE):
 

1. 4D Filtration 6x6x1 inch HEPA 13 Filter - Ideal for Extraction Air Filtration
   1. https://www.amazon.com/gp/product/B0CHWF5PYC
2. ½ inch Self Adhesive velcro strips
   1. I used this: https://www.amazon.com/dp/B01L9WC4X8 

To afix to printer: 

1. Measure out velcro tape for all for sides of the SMALL rectangle. 
2. Apply the velcro (any side) to the surface face of the SMALL rectangle so that it fills all surfaces
3. Cut strips to match the SMALL rectangle perimeter. 
   1. Stick velcro onto the already applied velcro and cut to proper length
4. Cut a small rectangle of velcro to apply to the fin in the same manner as steps 1-3 above. 
5. While the velcro is STILL attached to the velcro on the SMALL rectangle side, pull off the paper to expose the sticky side. 
6. Pull off paper on small fin applied velcro strip to expose sticky side
7. With SMALL rectangle facing back of printer vent and the fin FACING DOWN (it acts as a support)
   1. Place SMALL rectangle over vent and fully cover it, pressing firmly to attach it to the back of the printer
       

Printed with 3DFuel Tough PLA Pro +