Low Profile V0 Mount for Bento Mini
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modified Voron V0 cradle for Bento Mini to be as low profile as possible to make space for LEDs.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 31
- Makes
- 0
- Views
- 273
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is a modified version of the Bento Mini Cradle. The default cradle is kind of high and takes up a large part of the V0 side panel, which is likely good for air circulation around the bed but prevents the use of clip-in lights (i.e. Daylight On a Stick).
This is an extreme low profile modified version of the original cradle, which mounts the Bento Mini essentially right on the extrusion. This allows clearance for lighting.
Due to the low profile nature, the cradle is now printed as two pieces. Assembly is the same as original- mount both sides to the Bento with M3 screws, and then install on the rail.
The one downside is that a slight shadow is still cast when the bed drops far down below the top edge of the Bento Mini, but I believe this is a small compromise for being able to run both the Bento and LEDs.