Window sill holder for IKEA STYRBAR button
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple holder for IKEA STYRBAR. Design assumes use of original metal sheet and requires only few additional components.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 19
- Makes
- 0
- Views
- 182
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
We needed to place the IKEA STYRBAR button above the headboard in the bedroom, where it would be most accessible. We have a windowsill installed here and since it was the best spot to put it, I created this model. The holder could be made using magnets, but I didn't have any on hand, so I used the original plate that comes with the button.
Additional material you will need:
- Some thicker double-sided tape
- Two heat inserts size M3x5x4 (Voron size)
- Two m3 screws (I don't remember the exact length, I think 8-10mm)
Recommended settings
Material: PET-G or something with a similarly strong layers bonding
Layer height: 0.2
Perimeters: 4
Infill: 20% and more
Infill Type: It doesn't matter, I used Gyroid
Supports: They are not necessary, but I used them where the recess is for installing double-sided tape