Window sill holder for IKEA STYRBAR button
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple holder for IKEA STYRBAR. Design assumes use of original metal sheet and requires only few additional components.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
We needed to place the IKEA STYRBAR button above the headboard in the bedroom, where it would be most accessible. We have a windowsill installed here and since it was the best spot to put it, I created this model. The holder could be made using magnets, but I didn't have any on hand, so I used the original plate that comes with the button.
Additional material you will need:
- Some thicker double-sided tape
- Two heat inserts size M3x5x4 (Voron size)
- Two m3 screws (I don't remember the exact length, I think 8-10mm)
Recommended settings
Material: PET-G or something with a similarly strong layers bonding
Layer height: 0.2
Perimeters: 4
Infill: 20% and more
Infill Type: It doesn't matter, I used Gyroid
Supports: They are not necessary, but I used them where the recess is for installing double-sided tape