1 / 19
Low-friction Filament Spool Holder for i3 MK3S — image 1
1 / 19

Low-friction Filament Spool Holder for i3 MK3S

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I use some filaments that come on cardboard spools, they don't rotate smoothing on the stock MK3S spool holder.

Rating
0 / 5
Likes
2
Downloads
22
Makes
0
Views
212
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Recently bought a secondhand Prusa i3 MK3S, quickly discovered that the supplied spool holder is less than ideal when using cardboard spools, the spool grips, doesn't rotate easily and creates strain on the filament. 

I found quite a few solutions to provide smooth rotation, but all seemed overly engineered/complex to me. I like simple.

My design is simple, low cost, relatively quick, and flexible.

My solution was to create some left/right supports to sit on the existing spool support, and add a roller supported by common 608-2Z bearings.

The various parts will provide the option for a single spool (left or right side) only; or dual spool. (The only difference between the left and right outside supports is cosmetic, so that the M3 screw head is inserted from the front, and the hex nut is captured at the rear.)

I used a rotary tool to trim off the bottom of the supplied spool holder's outer lip to allow the Prusament spool to still fit on when the bearings/spindle were attached (I've found that Prusament has the smallest inner-diameter spool, so if this fits, all other spools I've used also fit). 

I also drilled a few 4mm holes (which are hidden when the bearing supports are added) to secure the bearing supports. (4mm holes to accommodate 3mm screws and allow a bit of wriggle room for final alignment).

Non-printed hardware:

608-2Z bearings: 2 (single spool), or 4 (double spool)
M3 x 35mm screws and nuts: 2 (single spool), or 3 (double spool)

All parts printed with PLA, 0.2mm, 15% infill, PrusaSlicer 
No supports for left, right and centre support parts, “Supports on build plate only” for the spindle(s).

Printed on Mini+ and MK3S   

Tags