Kayak or Boat plug
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is for a .75" plug with the hole measuring just ship of 19mm.
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 110
- Makes
- 0
- Views
- 381
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
This is a replacement boat plug that has an opening of about ¾" or about 19mm. It has a groove for grommet ¾" OD and 9/16" ID and 3/32" cross section.
Since you print it handle down you will get a nice flat seat and may not need the grommet.
Two varieties. My old plugs had a flat seat. I made a flat version and one that has a groove that fits over the flange at the entry. I don't know which is better. I would say the groove version has more surface making contact.
On my original plugs they ether did not come with an o-ring or they would dry out in the sun (where I left them) and fall off. It never seamed to make a difference in terms of seal.
Print instructions
Print knob down with a brim so it does not fall over. No supports should be needed.
I used PETG