1 / 1
Sliger CX Case 120mm / 92mm Fan Mount — image 1

Sliger CX Case 120mm / 92mm Fan Mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Parametric rear fan mount for the Sliger CX4713 and related cases.

Rating
0 / 5
Likes
2
Downloads
20
Makes
0
Views
186
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial

For .f3z: Fusion 360 → Design → Configure Table (on Ribbon bar) → Pick Fan Width

Created with M4 screws + nuts for fan to chassis mounting but you can change it to whatever.

Had successful prints with:
* Brim / brim ears
* More than 4 perimeter walls and/or 50%+ infill
* Orient the side adjacent the case's grill upwards to avoid supports.

NOTE: Model includes a single layer (0.2mm) bridge that needs to be removed from the finished print in screw holes. This mostly prevents the need for supports or issues caused by bridging these holes without supports.

Important: Pay special attention to the spacing to make sure the your mounting holes are as close to the center of Sliger vent grid openings as possible. Verify and modify parametric values!

Tags