Sliger CX Case 120mm / 92mm Fan Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parametric rear fan mount for the Sliger CX4713 and related cases.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 186
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
For .f3z: Fusion 360 → Design → Configure Table (on Ribbon bar) → Pick Fan Width
Created with M4 screws + nuts for fan to chassis mounting but you can change it to whatever.
Had successful prints with:
* Brim / brim ears
* More than 4 perimeter walls and/or 50%+ infill
* Orient the side adjacent the case's grill upwards to avoid supports.
NOTE: Model includes a single layer (0.2mm) bridge that needs to be removed from the finished print in screw holes. This mostly prevents the need for supports or issues caused by bridging these holes without supports.
Important: Pay special attention to the spacing to make sure the your mounting holes are as close to the center of Sliger vent grid openings as possible. Verify and modify parametric values!