Magnetic side door locks for Prusa Box by Printer Box
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are magnetic doors locks for the side doors of the prusa box.
- Rating
- 5 / 5
- Likes
- 50
- Downloads
- 222
- Makes
- 10
- Views
- 1,979
- Reviews
- 13
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
For both side doors you need
6 x M3 x 10 screws
6 x Square nuts
6 x Neodym magnets 8 x 4 mm (take the 8x4 file)
OR
6 x Neodym magnets 8 x 3 mm (take the 8x3 file)
Print the handle parts on the side and with supports. Take a look at the gcode.
Put the magnets into all parts. Press them all the way in. You will notice that the holes for magnets of the four holders are deeper than those for the two handle parts. This is intentional. The idea is to weaken the magnetic force a bit.
If you need to remove the magnets for some reason, you can do so with a small allen key. Just push the allen through the small hole on the top.
Insert the locks, counter them with the small counter plates and screw everything together.
If you are looking for the magnetic handle for the front and the back door, it's here:
https://www.prusaprinters.org/de/prints/118449-door-handle-for-prusa-box-by-printer-box