OSOYOO 5 Inch DSI Touch Screen Holder

Great simple design for the Osoyoo 5" touch screen allowing you use easily use Octodash.

This stand can be used upright or up-side-down allowing a 5-degree tilt or a 51.842-degree tilt.

Instructions:

1. Attach the ribbon cable to the screen
2. Slide screen into main_body_print (Note: take note of screen bezel is bigger on the bottom so make sure the 3D printed part is orientated correctly to match screen)
3. Press-fit the left_print and right_print to main_body_print ends while feeding the ribbon cable through the right_print slot
4. Screw small included screws that come with the screen 

OctoDash Setup:

Follow Until Step 4 and use driver set for 5" screen https://github.com/Z-Bolt/OctoScreen/wiki/Installing-OctoScreen-with-a-3.5%22-480x320-TFT-screen and then install Octodash https://unchartedbull.github.io/OctoDash/index.html

(Note if screen rotated and touch buttons are up-side-down(wrong way) use following code in the \boot\config.txt)

display_rotate=2
lcd_rotate=2

Print Requirements:

• main_body_print requires a brim to help it stick to the bed if not good luck :)
• Any Layer height
• Any filaments types(not flexible)
• No supports required

Have Fun :)