1 / 10
Voron 2.4 Multi-Tool Exhaust Cover with ECAS and PUG/GX12/Microfit — image 1
1 / 10

Voron 2.4 Multi-Tool Exhaust Cover with ECAS and PUG/GX12/Microfit

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix of the original Exhaust Filter that allows up to 5 tools, while keeping the ability to filter air through

Rating
4 / 5
Likes
45
Downloads
184
Makes
0
Views
1,530
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

This mod allows you to replace the original carbon filter, but let's you have up to 5 umbilical cables through the back of your printer. The design allows you to have a clean wiring inside the chamber and let's you manage all the CAN connections on the back of your printer whether you want to run all of them to the basement or use something like BTT CEB.

I also recommend to use VEFACH filter system by KevinAkaSam, as it lets you use the carbon pellets as well as HEPA filters and pairs very nicely with this mod.

For the front grill you have several options:

  • You can do PUG connectors. They are printable and configurable
  • If you want your cables to be detachable, you can use GX12 or Microfit Connetors
  • I've als made a cable guide to point the cables upwards, if you go with connectors

For the back part you need to get ECAS mounts, which can be purchased from Aliexpress or Amazon.

BOM

For the back case
  • Original bolts from your Voron build could be used to mount this together
  • 6x default Voron heat inserts (M3x4x5, 4mm length 5mm outer diameter) 4x for the back part
  • 1x to 5x ECAS couplers, depending on how many tools you would use
For the PUG exhaust grill
  • 2x more of heat set inserts
  • 2x M3x12mm for the front grill (M3x10 would probably do as well)

For the GX12 or Microfit you'd need those as well %)

Installation

Unmount your existing exhaust filter and disconnect your current connection to your toolhead. Undo the wiring from your toolhead to your CAN/USB controller, if it was connected through your gantry.

Install heat inserts to the exhaust housing. Then press fit the ECAS mounts to the channels you are going to use. The remaining holes should be sealed with ECAS plugs. I've printed mine with TPU for extra tightness.

Install heat insert to the bottom part of the grill and prepare your PUG pieces. If you have less than 5 tools, you are gonna need to also print the plugs to seal the unused holes. Insert all your PUGs and seals and then bolt two parts of the grill together.

Route the wires through the PUGs, then through the hole in the back and then through the exhaust housing. You can choose between the left and the right housing, depending on the side you want your wires to come out.

Place the VEFACH pieces inside the exhaust housing and then mount the housing and the grill together to the back of your printer.

From there it is up to you how to complete your wiring. I haven't completed my StealthChanger yet, so for now I have only one tool.

Printing Instructions

Use default Voron settings for all parts.

I've used tree supports for the exhaust housing, similar as I'd use them for the original part, but if your printer is good with bridging, you should be fine without them.

 

Tags