Triquetra Fidget Spinner with one 608 Bearing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Triquetra-themed Fidget Spinner that only uses one 608 bearing. Great for smaller hands and pretty quick to print!
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 152
- Makes
- 2
- Views
- 348
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial
I really wanted to see if I could turn the Triquetra into a fidget spinner (I've always loved that design). I have some friends who are counselors and often have younger clients who tend to open up more when they have something to “fidget” with. So, I print out a lot of spinners for them and wanted to have some original designs that only use a single 608 bearing and fit those with smaller hands.
I got great spin-time from a cheap 608 bearing off of Amazon. I'm sure there are a lot better bearings that could increase spin time, but the cheap ones worked just fine for me. The bearing caps are a remix that I came up with.
Note: The bearing is a tight fit. I use two pieces of wood to sandwich the spinner and bearing then press down until the bearing seats fully. It's not too difficult but does take a little effort.
Links:
- Bearing Caps: https://www.printables.com/model/1221928-fidget-spinner-bearing-cap-for-608-bearings
- Here is an Amazon link to the bearings I used: https://a.co/d/iMTwe83
Printing:
- Supports: None
- Infill: I recommend 100% to provide weight.
- Layer Height: I use .16 but .2 should work just fine.
- Material: PLA