Tronxy P802E Frame Braces
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Frame braces I made for my Tronxy P802E that got rid of most of the wiggles.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 47
- Makes
- 0
- Views
- 485
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Frame braces I made for my Tronxy P802E that got rid of most of the wiggles. I made some revisions to a few parts after making the ones that are on my printer so some will look a bit different then in the photos.
The braces on the front of the verticals are the most critical.
The usefulness of the bottom inside corner braces is debatable, but they are designed to tie in to the other braces.
Print instructions
Category: 3D Printer Parts Print Settings
Supports: Yes
Infill:
20%
Notes:
Meant to print in the orientation they load in. Use at least 3 perimeters. A few parts will require supports.
Post-Printing
Installation of some parts will require match drilling of holes into the printer acrylic frame.
The back side of the left and right vertical braces should fit snugly onto the printer frame verticals.
I think most of the screws used were m3. You don't need to use all the screw holes I put in the parts. - I didn't if you see my pics. For the connection between the top corner parts and the left and right verticals you will need to make sure the screw heads do not stick out too far or the inner ones could interfere with the carriage parts.