MeshNRW Heltec T114 Case - 3000mAh

This is a case for the Heltec T114 v2 with MakerFocus 3000mAh battery.

Designed for the use as a Meshtastic or Meshcore node.

Before you start:

This model has very small tolerances - Accurate printing required. If you are unsure, scale it up a little little bit.

Must print:

1. Body
2. Frontplate
3. Backplate
4. One of the Top Caps
5. Either a Clip or the placeholder for no clip
6. If you are using a rotary encoder for canned messages, print the rotary encoder cap

Things you need:

1. 2x M3x6 Screws (required)
2. 2x M3x10 Screws (required)
3. MakerFocus 3000mAh battery (required)
4. Heltec T114 v2 (required)
5. GPS-Module (optional)
6. Rotary Encode EC11 (optional)
7. SMA-Ipex connector, if you want an external antenna. (optional, mostly included in the T114 package)

Assembly:

1. Put the T114 into the body and align it with the USBC port (optionaly attach the GPS and bend it towards the top)
2. Slide the frontcover into the body
3. Attach the battery to the T114 and place it in the back of the body
4. Slide the backplate into the body
5. Put your selected cap on the top (Assembly is intuitive. In case you are using an internal antenna, place it next to the battery.
6. Use the longer screws for the two holes on the T114-Side and the shorter screws on the side of the battery. DO NOT PUNCTURE THE BATTERY!

+++ COMMERCIAL USE OF THIS MODEL IS FORBIDDEN  - PLEASE DROP ME A MESSAGE IF YOU FIND ANY VIOLATIONS +++

Enjoy.